Corrections

When we find a material error in a calculator, a formula or a published cost, we fix it and list it here. We do not list typos or wording changes. Our editorial policy explains how pages are checked.

Last updated

Report an error

Use the contact form. Tell us the page, the numbers you entered, what the calculator returned, and what you expected, with a source if you have one. We check each report and, if it is right, fix the page and add it below.

Correction log

  • Crushed limestone calculator

    The compaction setting (15% or 20%) was only adding about 1% to the tonnage, and the stone weight setting was ignored. Both now apply, so the tons shown are higher and match the numbers on the page.

  • Epoxy garage floor calculator

    Choosing full flake coverage was counted as light flake (0.03 lb per sq ft instead of 0.15). Full, medium and light now use 0.15, 0.09 and 0.03 lb per sq ft, and the worked example no longer says every floor is a 2-car garage.

  • Paver calculator

    The calculator counted every paver size as 4.5 pavers per square foot. It now uses 4 per square foot for 6 × 6 inch pavers and 1 per square foot for 12 × 12 inch pavers, so those sizes no longer give a count that is too high.

  • Retaining wall calculator

    The calculator counted every block as 1 square foot of wall face, whatever block you picked. It now uses the face size of the block you choose (8 × 18, 6 × 16 or 4 × 12 inches), so the smaller blocks no longer give a count that is too low.

  • Garage slab cost calculator

    The page is for a 24 × 24 ft slab, but the calculator was working out a 30 × 24 ft slab, so the yardage and cost were too high. It now uses 24 × 24 ft. The reinforcement choice also now changes the materials list (rebar, wire mesh or fibers) instead of always showing rebar.

  • Generator size calculator

    The sizing logic now adds the single largest motor starting load on top of the running load, instead of treating all starting loads alike.

  • Heat pump and subpanel calculators

    Both calculators had outdated walkthrough steps and fallback FAQ text that did not match their results. We replaced them.

  • Concrete driveway cost

    The installed-cost rate in the calculator was out of line with 2026 prices. It now returns $7.20 to $9.20 per square foot.

  • Asphalt cost calculator

    The installed price now changes with the asphalt thickness and the base depth you enter. Before, it did not follow them.