Methodology
This page explains how a SpanSizer calculator gets from the numbers you type to the quantity and cost it shows, and where those results can be off. It covers the calculators, the cost ranges and the price index. How pages are written and corrected is on the editorial policy page.
Last updated
1. From measurements to quantities
Each calculator starts with the size you enter and applies the geometry for that job: area for a slab or roof, volume for concrete or gravel, length for fencing or wire. It then converts that figure into the unit you buy. For concrete, for example, cubic feet are divided by 27 to get cubic yards, and the result is rounded up to a quantity you can actually order.
The formula and a worked example appear on every calculator page, so you can repeat the math by hand. The calculators run in your browser, so the numbers you type are not sent to us unless you submit a quote request.
2. Waste, overage and defaults
Material takeoffs add an allowance for cuts, spillage, uneven ground and compaction, because a real job needs more than the bare measurement. Where a calculator has a waste field, such as roofing or panels, the default is a typical starting value and you can change it. If your layout is complex, raise it.
Defaults are starting points. A calculator cannot see your site, so conditions it cannot know about, such as soft subgrade, steep access or an unusual shape, are your call.
3. How cost ranges are built
- DIY materials. Quantity multiplied by a national unit price for the materials only, shown as a range. It leaves out equipment rental, delivery fees that vary by supplier, and labor.
- Hired contractor. An installed price range per unit of work, such as dollars per square foot, which covers labor, equipment and the contractor's overhead. It can change with thickness, base depth or other inputs where the calculator takes them.
- City adjustment. When you pick a city, the hired-contractor range is scaled by a regional multiplier relative to the national average of 1.0. The DIY materials range is not scaled. The multiplier is based on local labor costs and is an approximation, not a local bid.
Every cost output is a planning range. It is not a quote, and a contractor who sees your site may be above or below it. The only firm price is a written bid.
4. The price index
The price index page charts U.S. Bureau of Labor Statistics producer price indexes for ready-mix concrete, cement, asphalt paving mix, sand, gravel and crushed stone, retrieved from the Federal Reserve's FRED service and refreshed monthly. A producer price index shows how prices move over time, not what you will pay per yard. We use it to see whether our calculator prices still match the market, and we update them when the trend says they have drifted.
5. Building codes
Where a calculator touches a code topic, such as wire size or footing depth, it follows a published model code and names the section on the page. Your city or county may have adopted a different edition or added rules of its own, and the local rule wins. Have your building department or a licensed professional confirm anything structural, electrical or load-bearing.
6. Known limits
- Results are estimates for planning and budgeting. They are not engineering designs.
- Prices change. Each page shows when it was last reviewed, and the review date is the date to trust.
- The regional adjustment applies to the hired-contractor range only, and it is available for a limited set of cities.
- Rounding and typical product sizes mean a supplier's own quote may differ slightly.
Found a result that looks wrong? Tell us through the contact form. Confirmed errors are listed on the corrections page.