Concrete Driveway Cost
By SpanSizer Editorial Team · Updated
A new concrete driveway costs about $6 to $10 per square foot installed in 2026 for a plain broom finish, which works out to roughly $4,300 to $7,200 for a typical 24 × 30 ft two-car driveway. Decorative finishes cost more: about $9–$13 per sq ft for exposed aggregate and $12–$18 for stamped concrete. Tearing out an old driveway adds $1.00–$2.50 per sq ft.
TL;DR
- $6–$10 per sq ft for a plain broom-finish driveway, installed.
- $4,300–$7,200 for a 720 sq ft two-car driveway, before removing an old one.
- +$1.00–$2.50 per sq ft to break up and haul away an existing driveway.
- Pour 5 inches, not 4, if anything heavier than a car will ever park on it. It adds about 20% to the concrete bill and nearly 50% to load capacity.
- Get 3 written quotes that spell out thickness, base depth, reinforcement and joint spacing. That's where cheap quotes cut corners.
Want a number for your driveway? Enter its length and width in the calculator on this page and choose concrete. It adjusts for new, replacement or resurfacing jobs.
Your project size
Estimated CONCRETE Driveway Turnkey Cost
Contractor Price Range
$5,760 – $7,360 ($7.20 – $9.20/sq ft)
Want a real price for this driveway co t e timator project?
Get up to 3 free quotes from local contractors. No obligation. Your numbers are included.
Multi-layer load distribution prevents wheel rutting and reflective frost heave cracking.
Materials list
| Material | Quantity | Unit | Notes |
|---|---|---|---|
| Primary Surface Material: CONCRETE | 800 | Sq Ft Coverage | Standard residential load-bearing cross section |
| Compacted Crushed Stone Road Base (#411 / #304) | 21 | Tons | 6-inch compacted aggregate base (AASHTO standard) |
| Non-Woven Geotextile Separation Fabric | 880 | Sq Ft | Prevents stone subbase contamination into subgrade |
Estimated cost: DIY vs. contractor
Cost of raw lumber, concrete, shingles, wire, or stone without equipment rentals or labor.
Full installation: permits, site prep, skilled trade labor, equipment, and structural warranty.
Average trade labor savings if executed as a skilled DIY homeowner project.
Concrete driveway cost per square foot
Most of the price is labor, base preparation and finishing, not the concrete itself. The finish is the biggest choice you control:
| Finish | Installed cost per sq ft (2026) | What you get |
|---|---|---|
| Plain broom finish | $6–$10 | Gray concrete with a textured, slip-resistant surface. The standard |
| Exposed aggregate | $9–$13 | The top layer is washed off to show the stones. Hides stains and tire marks well |
| Stamped / decorative | $12–$18 | Patterned and colored to look like stone, brick or slate. Needs resealing |
Simple single-color stamping sits at the low end of that last range. Multi-color patterns with borders can run well above $18 per sq ft.
Concrete driveway cost by size
| Driveway | Size | Area | Plain broom ($6–$10) | Exposed aggregate ($9–$13) | Stamped ($12–$18) |
|---|---|---|---|---|---|
| One car, short | 12 × 20 ft | 240 sq ft | $1,440–$2,400 | $2,160–$3,120 | $2,880–$4,320 |
| Two car, square | 20 × 20 ft | 400 sq ft | $2,400–$4,000 | $3,600–$5,200 | $4,800–$7,200 |
| One car, long | 12 × 40 ft | 480 sq ft | $2,880–$4,800 | $4,320–$6,240 | $5,760–$8,640 |
| Two car | 24 × 24 ft | 576 sq ft | $3,460–$5,760 | $5,180–$7,490 | $6,910–$10,370 |
| Two car, standard | 24 × 30 ft | 720 sq ft | $4,320–$7,200 | $6,480–$9,360 | $8,640–$12,960 |
| Three car | 30 × 30 ft | 900 sq ft | $5,400–$9,000 | $8,100–$11,700 | $10,800–$16,200 |
These are installed prices for new work on prepared ground. Replacing an old driveway adds removal (next section). A long sloped driveway, poor soil or a tight site pushes you toward the top of each range.
Replacing an old driveway: removal cost
If there's an existing driveway, it has to be broken up and hauled away first. Expect $1.00 to $2.50 per sq ft. Thick slabs, heavy rebar and long trips to the dump land at the high end.
For a 720 sq ft two-car driveway, that's $720 to $1,800 on top of the new concrete, so a full replacement runs about $5,000 to $9,000 with a broom finish.
Not every cracked driveway needs replacing. If the slab is level and the cracks are narrow, crack repair and resurfacing cost far less. If sections have sunk, heaved or broken into pieces, the base underneath has failed. A new surface over a bad base just cracks again. Our guide to driveway repair vs. replacement walks through the signs.
Thickness: 4 inches or 5?
Four inches is enough for cars and light pickups on a well-compacted base. Five to six inches is the right call if a delivery truck, RV, boat trailer or dump truck will ever use the driveway.
The extra inch costs less than people expect. Going from 4 to 5 inches adds about 20% to the concrete bill but increases load-carrying capacity by nearly 50%. On a 720 sq ft driveway, that's about 2.5 more cubic yards, roughly $390 of concrete at $155 a yard (see our concrete cost per yard guide).
Our recommendation: pour 5 inches unless the budget truly can't stretch. Cracked driveways almost always trace back to a thin slab, a soft base, or both.
What else changes the price
- Base preparation. Concrete is only as good as the ground under it. Grading, removing soft soil and compacting a gravel base is a real part of the bill. Our calculator assumes a 6-inch compacted stone base.
- Reinforcement. Rebar, wire mesh or fiber-reinforced concrete. Rebar costs the most and does the most to hold cracked sections together; size it with the rebar calculator.
- Concrete strength. In freeze-thaw climates, ask for 4,000 psi, air-entrained concrete. Building codes in severe-weather regions require at least 3,500 psi air-entrained concrete for garage floors and other exposed slabs.
- Access. If the ready-mix truck can't back up to the forms, a pump or extra labor adds cost.
- Slope and drainage. Steep driveways need more forming and careful finishing; water must drain away from the garage and house.
- Permits and the apron. Many cities require a permit for the section where the driveway meets the street (the apron or curb cut). Call your local building or public works office before you sign a contract.
- Region. Labor rates vary a lot between metro areas. Use the location setting in the calculator to adjust.
Worked example: replacing a two-car driveway
You're replacing a cracked 24 × 30 ft (720 sq ft) two-car driveway with a plain broom finish, 5 inches thick.
- Removal: 720 sq ft × $1.00–$2.50 = $720–$1,800.
- New driveway, broom finish: 720 sq ft × $6–$10 = $4,320–$7,200.
- Extra inch of thickness (4 → 5 in): about 2.5 cubic yards × $155 = ~$390 in concrete.
- Total: about $5,430–$9,390.
That's a realistic budget to hold your quotes against. A bid far below it usually means a thinner slab, little or no base work, or no reinforcement. Ask before you sign.
How to compare driveway quotes
Concrete quotes are hard to compare because contractors leave out different things. Ask every contractor to write these down:
| Ask for | A good answer looks like |
|---|---|
| Slab thickness | 4 in for cars; 5–6 in for trucks, RVs, trailers |
| Base | Depth of compacted gravel and how it's compacted |
| Reinforcement | Rebar size and spacing, wire mesh, or fiber, in writing |
| Concrete mix | Strength in psi; air-entrained in freeze-thaw areas |
| Control joints | A jointing plan. Joints no farther apart than about 30 × the slab thickness (about 10 ft for a 4-in slab, 12.5 ft for 5 in), cut to 1/4 of the slab depth |
| Finish and curing | Broom, exposed aggregate or stamped; how the slab is cured |
| Removal and cleanup | Included or extra; where the debris goes |
| Permit | Who pulls it, and whether the apron is included |
| Sealing | Included, and the recommended resealing schedule |
Two quotes that match line by line are a fair comparison. A quote that won't put thickness, base and reinforcement in writing isn't one.
Concrete vs. asphalt driveway cost
Asphalt costs less up front, while concrete usually lasts longer and needs less routine upkeep. Plain concrete driveways commonly last 30–40 years or more, while asphalt typically lasts 15–30 years and needs periodic sealcoating. The full side-by-side, including gravel and pavers, is in our asphalt vs. concrete driveway cost comparison.
Mistakes that cost money
- Choosing the lowest bid without comparing scope. The usual savings come from a thinner slab or a skipped base. Use the checklist above.
- Pouring 4 inches where trucks park. One heavy delivery can crack a thin slab. The extra inch is cheap insurance.
- Skipping control joints, or spacing them too far apart. Concrete will crack; joints decide where. Without them, cracks run wherever they like.
- Driving on it too early. Ask your contractor how long to wait before parking a car on the new slab, and keep heavy vehicles off longer.
- Never sealing a stamped or exposed-aggregate finish. Decorative surfaces need resealing every few years to keep their color and resist salt and stains.
When to hire a pro
A driveway is not a weekend DIY pour. A 24 × 30 ft two-car driveway needs 9–12 cubic yards of concrete placed, leveled, jointed and finished in one go, before it starts to set. That takes an experienced crew, forms, a compactor and finishing tools. DIY makes sense for the prep you can see (removing an old gravel or paver surface, landscaping the edges), not for the pour.
Ready to price your driveway? The quote form on this page sends your driveway details to up to 3 local concrete contractors.
FAQ
How much does a 2-car concrete driveway cost?
A typical two-car driveway is 400 to 720 sq ft. With a plain broom finish at $6–$10 per sq ft, expect about $2,400–$4,000 for a 20 × 20 ft driveway and $4,320–$7,200 for a 24 × 30 ft one. Add $1.00–$2.50 per sq ft if an old driveway has to be removed first.
How much does it cost to pour a 20 × 20 concrete driveway?
A 20 × 20 ft driveway is 400 sq ft, so a plain broom finish costs about $2,400–$4,000 installed. Exposed aggregate runs about $3,600–$5,200 and stamped concrete $4,800–$7,200. At 4 inches thick it takes about 5.25 cubic yards of concrete, including a little extra for waste.
Is a concrete driveway worth the cost?
Usually, if you plan to stay in the home for years. Concrete costs more than asphalt or gravel up front, but it commonly lasts 30 to 40 years or more with little upkeep beyond cleaning and occasional crack sealing. On a short timeline or a tight budget, asphalt or gravel can be the better value.
How long does a concrete driveway last?
A well-built concrete driveway commonly lasts 30 to 40 years or more. The biggest factors are a properly compacted base, the right thickness for your vehicles, correctly spaced control joints, and drainage that keeps water from pooling. Stamped finishes last 20–30 years but need resealing every few years.
Does a concrete driveway need to be sealed?
Plain broom-finish driveways don't strictly need it, but a penetrating sealer helps them resist de-icing salt, oil and freeze-thaw damage. Stamped and exposed-aggregate finishes do need sealing to protect their color and surface, typically every 2–5 years. Professional sealing of a decorative driveway costs about $1–$2 per sq ft.
Sources
- BuilderMuse – Concrete Driveway Cost 2026 (cost per sq ft by finish, removal, two-car totals)
- LawnStarter – How Much Does a Concrete Driveway Cost in 2026?
- Concrete Network – What's the Average Cost of a Concrete Driveway?
- Concrete Network – Concrete Driveway Construction Essentials (thickness, joints)
- JLC – Q&A: Preventing Cracks in Concrete Slabs (thickness, joint spacing)
- HomeAdvisor – Stamped Concrete Cost
- Fixr – Stamped Concrete Driveway Installation Cost (sealing cost)
- Penn State PHRC – Concrete 101 handout (minimum concrete strength by weathering exposure)
- UseCalcPro – Concrete Driveway Cost Calculator (concrete vs. asphalt lifespan)