Sod Calculator

A 50 × 35 ft lawn, which is 1,750 square feet, needs 5 pallets of sod once you add 10% for cuts and curves. That is 1,925 square feet of sod at 450 square feet per pallet.

Free · No sign-up · Last reviewed

Quick start:

Your project size

(ft)
ft
(ft)
ft

Total Turfgrass Sod Pallets Required

7 Pallets (3,080 sq ft inc. waste)

Sod Roll Pieces & Leveling Soil

1,154 Rolls (16"×24") | 4.8 yd³ Leveling Bed

Want a real price for this sod calculator project?

Get up to 3 free quotes from local contractors. No obligation. Your numbers are included.

Materials list

MaterialQuantityUnitNotes
Fresh Harvested Turf Pallets (450 sq ft/pallet)7PalletsIncludes 10% cutting waste along curves & edges
Starter Lawn Fertilizer (10-10-10 or 15-20-10)20PoundsPromotes rapid root anchoring into native soil
Screened Topsoil Pre-Lawn Dressing (1/2-in layer)4.8Cubic YardsRoll-graded bed eliminates air pockets under sod
Water Roller Rental Allowance1RollerPresses sod roots directly into prepared subsoil

Estimated cost: DIY vs. contractor

National Average
DIY Raw Materials Only
$1,849 – $2,239

Cost of raw lumber, concrete, shingles, wire, or stone without equipment rentals or labor.

Hired contractor
$2,660 – $4,340

Full installation: permits, site prep, skilled trade labor, equipment, and structural warranty.

Estimated Sweat Equity
~$1,456

Average trade labor savings if executed as a skilled DIY homeowner project.

Turfgrass Pallet Geometry & Trimming Waste Formula

Rendering formula...

Lawn Coverage Math for 70' × 40' (2,800 sq ft)

  1. Net Lawn Area = 70 ft × 40 ft = 2,800 sq ft.
  2. Factoring 10% cutting waste = 2800 × 1.10 = 3,080 sq ft.
  3. Pallet Count = 3080 sq ft ÷ 450 sq ft per pallet = 6.84 → 7 full pallets.
  4. Roll Piece Equivalent = 3080 ÷ 2.67 sq ft/roll = 1,154 pieces.
Tip: In National Average, install sod within 24 hours of pallet delivery. Stagger sod seams in a brick-layer pattern to prevent visible seam lines.

Quick Reference Sizing & Coverage Table

Standard commercial specifications and pre-calculated project benchmarks.

Lawn Area (Sq Ft)Gross Area (10% waste)Pallets Needed (450 sq ft)Total Rolls (9 sq ft/roll)Turnkey Installation Cost
1,000 sq ft1,100 sq ft3 Pallets123 Rolls$1,200 – $1,800
2,000 sq ft2,200 sq ft5 Pallets245 Rolls$2,200 – $3,200
3,500 sq ft3,850 sq ft9 Pallets428 Rolls$3,800 – $5,400
5,000 sq ft5,500 sq ft13 Pallets612 Rolls$5,500 – $7,900
TPI Guideline Specifications for Turfgrass Sod

Turfgrass Producers International (TPI) Installation Standards

Sod must be laid within 24 to 36 hours of harvesting to prevent overheating in the pallet core. Soil must be pre-tilled to a depth of 3 inches with starter fertilizer incorporated. Joints must be tightly staggered in a brickwork pattern with seam rolling immediately following install.

How to use the sod calculator

  1. Enter the length and width of the area in feet. Split an odd-shaped lawn into rectangles and add them up.
  2. Choose the square feet on a pallet from your supplier and the waste allowance.
  3. Read the pallets, the leveling soil and the starter fertilizer, then compare the contractor range with your quotes.

How many pallets of sod do I need?

Multiply the length by the width, add a waste allowance, and divide by the square feet on a pallet. Round up to a whole pallet. Mississippi State University Extension says pallets usually hold 450 to 500 square feet, and that you should order about 5 percent extra.

Pallets = Length × Width × (1 + Waste) ÷ Sq ft per pallet, rounded up

For 50 × 35 ft with 10% waste on 450 sq ft pallets: 1,750 × 1.10 = 1,925 sq ft ÷ 450 = 4.28, which rounds to 5 pallets.

LawnAreaWastePallets (450 sq ft)
25 × 20 ft townhome yard500 sq ft5%2
50 × 35 ft front lawn1,750 sq ft10%5
80 × 50 ft backyard4,000 sq ft10%10

Pick 5% for a simple rectangle and 10% or 15% for curves, beds and angles. If your total lands just over a whole pallet, a partial pallet is often cheaper than a full one, so ask your supplier.

How should I prepare the soil for sod?

Mississippi State Extension says to finish site preparation before delivery, because fresh-cut sod will not tolerate sitting on a pallet for long. Sod does best over bare ground, so kill existing grass and weeds first. A soil test is inexpensive, and compost worked into the top 6 to 10 inches helps heavy clay. The calculator adds a half-inch layer of screened topsoil for leveling, which is 3.0 cubic yards for the 50 × 35 ft lawn.

How do I lay and water new sod?

Lay the first row along a straight edge, stagger the ends of the pieces like bricks, and leave the trimming for last. Staggering reduces erosion along straight seams. Start watering right away, until the soil is soft underfoot but not soggy. After the first week, daily watering is usually enough, and after two or three weeks every other day may do. Sod that turns bluish-gray needs more water.

Frequently asked questions

How much does sod cost?

For the 50 × 35 ft lawn, the calculator shows about $1,321 to $1,600 in materials for a DIY job and $1,663 to $2,713 with a contractor, at national averages. Prices vary a lot by grass type, region and delivery distance, so ask your supplier for a quote per pallet.

How many pieces of sod is that?

The calculator also shows the count in 16 × 24 inch pieces, which are 2.67 square feet each. The 50 × 35 ft lawn needs 721 pieces. Big rolls are also sold, but Mississippi State notes they need special equipment to lay.

When is the best time to lay sod?

Lay sod as soon as it is delivered, and not in extreme heat or on frozen ground. The best months depend on your grass type and region, so ask your local supplier or county extension office.

Sources and review

Prices and quantities come from the calculator above. Last reviewed . How our calculators work.