Asphalt Driveway Cost
By SpanSizer Editorial Team · Updated
A new asphalt driveway costs about $4.95 to $6.33 per square foot installed in 2026, which is $3,564 to $4,554 for a 24 × 30 ft two-car driveway. Tearing out an old driveway and repaving raises that to $6.93 to $8.86 per sq ft, while resurfacing a sound one costs $3.04 to $3.88.
TL;DR
- New asphalt driveway: $4.95–$6.33 per sq ft installed, including the gravel base.
- Tear out and repave: $6.93–$8.86 per sq ft.
- Resurface (overlay) a sound driveway: $3.04–$3.88 per sq ft.
- Two-car driveway (24 × 30 ft): $3,564–$4,554 new, $2,187–$2,795 resurfaced.
- Concrete costs more upfront: $7.20–$9.20 per sq ft in our driveway calculator.
Enter your own length and width in the calculator below; it's set to asphalt and shows new, replacement and resurfacing prices.
Your project size
Estimated ASPHALT Driveway Turnkey Cost
Contractor Price Range
$3,960 – $5,060 ($4.95 – $6.33/sq ft)
Want a real price for this driveway co t e timator project?
Get up to 3 free quotes from local contractors. No obligation. Your numbers are included.
Multi-layer load distribution prevents wheel rutting and reflective frost heave cracking.
Materials list
| Material | Quantity | Unit | Notes |
|---|---|---|---|
| Primary Surface Material: ASPHALT | 800 | Sq Ft Coverage | Standard residential load-bearing cross section |
| Compacted Crushed Stone Road Base (#411 / #304) | 21 | Tons | 6-inch compacted aggregate base (AASHTO standard) |
| Non-Woven Geotextile Separation Fabric | 880 | Sq Ft | Prevents stone subbase contamination into subgrade |
Estimated cost: DIY vs. contractor
Cost of raw lumber, concrete, shingles, wire, or stone without equipment rentals or labor.
Full installation: permits, site prep, skilled trade labor, equipment, and structural warranty.
Average trade labor savings if executed as a skilled DIY homeowner project.
Asphalt driveway cost per square foot
The price per square foot depends mostly on what's already there. A new driveway on bare ground needs digging and a compacted stone base before any asphalt goes down. A replacement adds removing the old surface. A resurface keeps the old base and adds only a new top layer.
| Job | Installed cost per sq ft | What it includes |
|---|---|---|
| New driveway | $4.95 – $6.33 | Grading, gravel base, hot-mix asphalt, compaction |
| Tear out and repave | $6.93 – $8.86 | Removal and haul-off, plus everything in a new driveway |
| Resurface (overlay) | $3.04 – $3.88 | Cleaning, patching, tack coat and a new asphalt layer |
Doing the work yourself isn't realistic for hot asphalt, since it has to be spread and rolled while hot with paving equipment. The materials alone for a new 24 × 30 ft driveway come to $1,782 to $2,228 in our calculator, which shows how much of the price is equipment and crew time.
Asphalt driveway cost by size
| Driveway | Area | New | Tear out and repave | Resurface |
|---|---|---|---|---|
| 1-car pad, 10 × 20 ft | 200 sq ft | $990 – $1,265 | $1,386 – $1,771 | $608 – $776 |
| 2-car, 20 × 24 ft | 480 sq ft | $2,376 – $3,036 | $3,326 – $4,250 | $1,458 – $1,863 |
| Single lane, 12 × 50 ft | 600 sq ft | $2,970 – $3,795 | $4,158 – $5,313 | $1,823 – $2,329 |
| 2-car, 24 × 30 ft | 720 sq ft | $3,564 – $4,554 | $4,990 – $6,376 | $2,187 – $2,795 |
| 2-car long, 18 × 50 ft | 900 sq ft | $4,455 – $5,693 | $6,237 – $7,969 | $2,734 – $3,493 |
Very small jobs often cost more per square foot than these figures, because a paving crew has a minimum charge for bringing out a truck and roller.
Resurface or replace?
Resurfacing makes sense when the base is still solid: the surface is worn, faded or has fine cracks, but there are no deep ruts, sunken spots or wide cracks that keep coming back. Those signs mean the base has failed, and a new top layer will crack the same way within a few years.
On a 24 × 30 ft driveway the difference is large: $2,187 to $2,795 to resurface against $4,990 to $6,376 to tear out and repave. Ask a paver to check the base before you decide, and get the recommendation in writing. Our guide to driveway repair vs. replacement lists the signs of a failed base.
How thick should an asphalt driveway be?
Thickness changes the tonnage, so it changes the price. In our asphalt cost calculator, the same 24 × 30 ft driveway on a 6-inch stone base costs:
| Asphalt thickness | Hot-mix needed | Installed cost |
|---|---|---|
| 2 inches | 9.7 tons | $2,855 – $3,637 |
| 3 inches | 14.6 tons | $3,370 – $4,306 |
The third inch adds about $515 to $669 (derived: $3,370 − $2,855 and $4,306 − $3,637). A thicker driveway handles heavier vehicles better; if you park a truck, an RV or a trailer, ask your paver what thickness they recommend for that load. Our asphalt calculator converts any thickness into tons.
What else changes the price
- Removing the old surface. In our asphalt cost calculator, repaving that 24 × 30 ft driveway costs $4,536 to $5,796 if the old one is asphalt, and $5,314 to $6,790 if it's concrete, since concrete is heavier to break up and haul away.
- The base. Soft or wet ground may need deeper digging and more stone than the 6 inches our calculator assumes.
- Access and slope. Steep drives, tight turns and long hauls from the street add labor.
- Edges and drainage. Curbs, edging and culverts at the street are usually priced separately.
- Your area. Labor rates vary a lot by region; the calculator above can adjust for your city.
Asphalt vs. concrete driveway cost
Asphalt costs less to put in. Our driveway calculator prices a new concrete driveway at $7.20 to $9.20 per sq ft, against $4.95 to $6.33 for asphalt. Asphalt needs periodic sealcoating and eventually a resurface, while concrete needs less routine surface upkeep. Our concrete driveway cost page has full concrete prices by size and finish, and the asphalt vs. concrete comparison looks at the long-term costs.
How to compare asphalt driveway quotes
- Get at least three written quotes for the same size and thickness.
- Check that each quote states the asphalt thickness after compaction and the depth of the stone base.
- Ask whether removal and haul-off of the old driveway is included.
- Ask how drainage will be handled so water runs off the driveway, not toward the house.
- Check the contractor's license and insurance, and ask what the warranty covers.
Want local prices for your driveway? The quote form on this page sends your project to up to 3 paving contractors who serve your ZIP code.
FAQ
How much does a 2-car asphalt driveway cost?
A 24 × 30 ft two-car driveway costs about $3,564 to $4,554 new in our calculator, or $4,990 to $6,376 if an old driveway has to be removed first. A narrower 20 × 24 ft driveway runs $2,376 to $3,036.
Is it cheaper to resurface or replace an asphalt driveway?
Resurfacing is cheaper, at $3.04 to $3.88 per sq ft against $6.93 to $8.86 to tear out and repave. It only works if the base underneath is still sound; over a failed base, the new layer cracks again.
How much is asphalt per ton?
Our asphalt calculator uses $105 to $135 per ton for hot-mix. A 24 × 30 ft driveway at 3 inches thick takes about 14.6 tons, but the delivered material is only part of the installed price.
Why is my quote higher than these prices?
Small jobs carry a crew minimum, and steep or tight sites, poor soil, long removal hauls and drainage work all add cost. Ask the contractor to list each item so you can see where the difference comes from.
How long does an asphalt driveway take to install?
Paving itself is usually a one- or two-day job once the base is ready. Ask your contractor how long to wait before driving on it, since fresh asphalt stays soft while it cools, especially in hot weather.
Sources
- SpanSizer driveway cost estimator and asphalt cost calculator (all prices on this page, runs listed below)