Retaining Wall Drainage: Pipe, Gravel & Fabric Done Right
Need Exact Math for Your Project?
Launch our free online tool: Retaining Wall Calculator
Retaining Wall Drainage — Assembly Anatomy
Interactive 3D Isometric Engineering Rig • Verified Model
Most retaining walls that bulge, lean or collapse fail because of water trapped behind them, not because the blocks were too weak. Wet soil is heavier than dry soil and pushes harder, and in cold climates it can freeze and expand. Good drainage gives that water a way out: a column of clean stone behind the wall, a perforated pipe at the bottom, fabric to keep soil out of the stone, and an outlet where the water can go.
TL;DR
- Drainage stone: about 12 inches of clean, washed stone directly behind the blocks.
- Drain pipe: a perforated pipe at the base of the wall, behind the blocks, sloped to an outlet.
- Fabric: between the native soil and the drainage stone, so fines don't clog it.
- Outlet: the pipe has to come out somewhere lower, to daylight or a drain.
- A 30 ft × 3 ft block wall: about 5.9 tons of drainage stone and 30 ft of pipe in our calculator.
How the drainage layers fit together
From the front of the wall back:
- The blocks, set on a compacted, level base pad with the first course partly buried.
- The drainage stone, clean angular stone such as #57, filling the space behind the blocks. Our retaining wall calculator uses a 12-inch column.
- The drain pipe, a 4-inch perforated pipe at the bottom of the stone, running the length of the wall.
- Filter fabric, laid against the native soil so it separates the soil from the stone.
- Compacted backfill behind that, finished with a layer of soil or a swale at the top to steer surface water away.
Material list for a 30 ft wall
For a wall 30 ft long and 3 ft high, our retaining wall calculator lists:
| Material | Quantity |
|---|---|
| Segmental wall blocks | 116, including an 8-inch buried course |
| Cap stones | 20 |
| #57 washed drainage stone | 5.9 tons |
| Crushed stone base pad (6 inches deep, 24 inches wide) | 1.6 tons |
| 4-inch perforated drain pipe | 30 ft |
To price a whole wall, our retaining wall cost calculator includes the drainage stone and pipe in its installed price: a 35 ft × 3.5 ft block wall comes to about $3,920–$7,105.
The drain pipe: where and how
- Put it low. The pipe sits at the bottom of the drainage stone, behind the first course, where water collects.
- Slope it. The pipe needs a steady fall toward its outlet so water doesn't sit in it.
- Give it an exit. Run the pipe out past the end of the wall to daylight, or into a drain line. A pipe with no outlet just fills up.
- Keep it clean. A sock-wrapped pipe or fabric around the stone helps keep silt out. Some builders add a cleanout so the pipe can be flushed later.
Fabric: what it does
Without fabric, fine soil slowly washes into the drainage stone and fills the gaps. Over time the stone stops draining and the wall is back to holding wet soil. Laying a non-woven filter fabric between the native soil and the stone keeps the stone clean. Don't wrap the fabric in front of the blocks, where it would show.
Signs your wall has a drainage problem
- Water seeping through the joints or pooling at the base after rain.
- Soil washing out from under the bottom course.
- The wall leaning outward, bulging in the middle or cracking.
- White staining on the face of the blocks, from water moving through them.
A small amount of water at the outlet after rain is normal; that's the system working. Water coming through the face is not.
When to call a professional
Low garden walls with good drainage are a reasonable DIY job. Tall walls, walls holding back a slope or a driveway, and walls near buildings often need geogrid reinforcement and an engineer's design, and many places require a permit above a set height. Ask your building department before you start a tall wall.
FAQ
What gravel goes behind a retaining wall?
Clean, washed, angular stone such as #57, with the fine particles washed out so water can flow through it. Avoid stone dust or dirt-filled gravel, which packs tight and holds water.
How much drainage stone do I need?
For a 12-inch column behind the wall, our calculator lists about 5.9 tons for a 30 ft × 3 ft wall. Use the retaining wall calculator for your own length and height.
Do short retaining walls need drainage?
Yes. Even a low garden wall holds back wet soil after rain. A stone backfill and, on longer walls, a drain pipe keep it from slowly pushing out of line.
Do retaining walls need weep holes?
Solid poured or block walls without a drain pipe often use weep holes to let water through. Segmental block walls are usually drained with stone and a pipe behind them instead.
Sources
- SpanSizer retaining wall calculator and retaining wall cost calculator (quantities and prices on this page)
Rather hire it out? Compare local landscaping quotes
Tell us about your project and we'll share it with up to 3 contractors who serve your ZIP code. Always ask for proof of license and insurance before you hire.
Quantities come from the same formulas as our calculators, and prices come from the sources listed in each guide. Read how SpanSizer works.